The Pressure Sensitive Adhesive Specialists in Adhesive Tapes & Glues
PSA Solutions, are now an: Official Frog Tape® UK supplier. This FrogTape® is a 36mm x 41.1 Metre delicate surface tape which is a low adhesion painters tape, designed for use on: Freshly painted surfaces (24 hours old), Primed plasterboard, Wallpaper, Finished wood (Polyurethane, Stain), Veneer / Laminate / Vinyl, and other similar surfaces.
FrogTape - Delicate surface, will remove cleanly from most surfaces for up to 21 days and even 7 days in direct sunlight.
What makes FrogTape different from other painters tapes, is that it is the only masking tape treated with: PaintBlock® Technology, and is not just another masking tape
What is Paint Block® Technology?
PaintBlock® technology, is a super-absorbent polymer which reacts with latex paint, and instantly gels to form a micro-barrier. This micro barrier seals the edges of the tape, preventing paint bleed on to the surface.
The answer is PaintBlock® Technology. FrogTape® is the only painter's tape treated with PaintBlock® Technology.
PaintBlock is a super-absorbent polymer which reacts with latex paint and instantly gels to form a micro-barrier that seals the edges of the tape, preventing paint bleed.
Reacts with latex paint and instantly gels to form a micro-barrier that seals the edges of the tape, preventing paint bleed.
How To Use FrogTape®
There are no special techniques - or methods - that you need to use with FrogTape®; but, here are some general tips for applying this tape to trim or other surfaces.
Please Note: FrogTape® was designed for use with emulsion paints for interior/exterior home painting projects. If you wish to use this masking tape in another application you must test before using it.
How do you apply FrogTape®?
Firstly, clean the surface to be masked, and make sure it is dust-free and dry. If the surface has been recently painted, make sure the paint has cured (dried throughout).
For accurate placement, adhere this masking tape in short sections to avoid stretching the tape, and make sure it is flush to the edge that you will be painting.
Next, using a putty knife or 5-in-1 tool, press the tape you laid to burnish it to the surface you are masking. If you are painting more than one coat of paint, it is a good idea to remove and re-apply the tape in between each coat. If you are taping on a textured surface, some specialized taping techniques may be required. See the: How to use this tape on textured surfaces, below for more information.
How do you remove FrogTape®?
Remove this tape immediately after you are finished painting, as this will help prevent the paint from bridging over the tape and tearing when you remove it. When emulsion paint begins to dry, it becomes rubbery (like an elastic band) and has a tendency to pull. When removing this tape, remove the tape slowly and pull at a 90-degree angle.
If the new paint does begin to tear, gently score the edges with a razor blade. If the tape begins to tear the wall board when it is being removed, this likely means you have masked on a poorly bonded surface. Try softening the tape's adhesive with a blow dryer first.
How to use this tape on textured surfaces
Getting a clean line on a textured surface with FrogTape® alone can be tricky. It is virtually impossible to fill in all of the nooks and crannies that a texture surface has. If FrogTape doesn't get completely pressed down into every crevice on your textured wall, paint will leak underneath.
If your surface is lightly textured, using a specialized technique may not be necessary. Be sure to firmly press the tape edges down using a knife or 5-in-1 tool. It is always a good idea to test your taping skills before taping off and painting an entire room.
For best results on textured surfaces follow these steps
Apply the tape directly onto Wall A along the corner where it meets Wall B. For this example, Wall B is the surface to be painted.
Secure the tape by pushing it down with your fingers into each "nook and cranny".
Run a flat tool firmly down the length of the tape to further ensure it is pressed down into the textured surface. You can also use a 5-in-1 tool.
Apply a very thin coat of the original colour of Wall A onto Wall B and along the edge of the tape. This will activate PaintBlock® and seal the edge of the tape.
Let the paint dry.
Using the colour with which you want to paint Wall B, apply a coat of paint along the edge of the tape.
Paint the rest of your wall.
Run a box cutter or utility knife lightly along the edge of the tape in the corner. Be careful not to press too firmly as to harm the surface of your wall.
Remove the tape at 180 degree angle at a slow and steady pace.
Enjoy your newly painted accent wall and sharp paint lines.
Surface preparation is paramount for achieving the required bond when using this pressure sensitive adhesive. Read our Surface Preparation and Application Guide for more information.
Not sure if this Painters' Masking Tape is right for you?
If you are not sure if this Frog Tape is right for your individual requirements please do not hesitate to contact our friendly sales team and we will be happy to help you understand the right tape for your requirements.
Do you require a Certificate of Conformance and traceability?
If you require a Certificate of Conformance, please contact us after ordering (either by phone or email) and we will get this sent out to you with your order.
PSA Solutions offers the following shipping options:
- Mainland UK shipping for orders over £30 (excluding VAT) is free
- Mainland UK shipping for orders under £30 (excluding VAT) is only: £4.99
- Signed for - up to 3 working days is only: £5.99
- Next day delivery - when ordered before 12pm is only: £11.99
- Using your own carrier - your items will usually be available for collection after 48 working hours, simply contact us with your collection date
- Europe starts from only: £22.20
- US, China, Middle East & South East Asia only: £43.78
- Rest of the world from only: £61.58
If in the unfortunate event that your goods are damaged in transit - or are accepted by PSA Solutions as being faulty due to factors beyond our control - you will be advised to return such goods and a full refund may be offered should you not require replacement goods being dispatched to you. PSA Solutions reserve the right to apply charges for handling and transit on such occasions. It is your responsibility to check the goods in the presence of the courier, and if required note when signing that goods have been damaged. Alternatively just a signature will confirm that goods have been received in good order and that thereafter refunds may not be considered. Please contact us if you do experience any difficulties and we will try our best to help you.